A series of corners and offsets demonstrating the flexibility of a plywood system. This particular pictures illustrates the barn door hinge.

A outside wall of Gates Horizontal Rod system showing the top 2x4 waler, 5/8" walers in place engaging ties, and Gates staging bracket. The form is braced to the outside bank.

A close up of the staging and 5/8" engaged rods. Notice the rods breaking in the middle of a panel between the two ties.

Low wall 32" x 4' panels

A close-up of the Gates Horizontal Rod staging bracket. It is a single plank bracket used without a handrail at no higher than 60" off grade.

This detail shows a 8" plastic Gates Rebar Hanger. The plastic comes only in the 8". Notice the two slots for a "snap in" rebar application. Gates also manufactures a steel rebar hanger in the 8",10",12" sizes.

Gates Horizontal Rod system EZBB ties

• 4" through 36"
• Galvanized twisted 11 ga. tie CB ties
• Available 8",9",10",12"
• Black wire welded tie
• Crisp breakback

Hinged outside and inside corners

• Continuous hinge
• Barn door hinge
• Strap hinge utilizing a 5/8" cane rod

Left to Right, Top to Bottom

• 17" Angular Tie Cutter
• Chisel End Tie Cutter - 6' & 8'
• Clean Out Tool
• Gates Rod Tie Cutter